Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
decoding address lines on TI 994a
#5
The X-10 was a module that connected into the TI along with a cable that attached between the TI Joystick port and the X-10 household controller that controlled individual X-10 devices. The module software allows you to program the controller--and it then carries out the instructions. The computer is only necessary to make program changes. I have one. . .

The MBP (or MBP-II) PEB cards were probably the A/D cards you were thinking of. I think the last run of those was done by Cecure Electronics in the mid-1990s.

It is also possible to build a A/D board using the TI or Willforth prototype boards (or likely with the one I designed but I haven't done a run of these yet).
Enter my mind at your own risk!


Messages In This Thread
decoding address lines on TI 994a - by sjt99 - 04-18-2014, 05:29 PM
RE: decoding address lines on TI 994a - by sjt99 - 04-18-2014, 10:22 PM
RE: decoding address lines on TI 994a - by ksarul - 04-19-2014, 02:55 PM
RE: decoding address lines on TI 994a - by sjt99 - 04-19-2014, 10:28 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)