Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PEB Power Supply redesign
#1
Hello,
I obtained an old PBE box with the interface card, the 32K Mem Expansion, Disk I/O controller and an RS232 interface card inside. The cards are in good condition, but the power supply board has 2 bad inductors on it and looking over the design, I was thinking of redesigning the Supply board and adding regulators for each of the voltages. Has anyone thought of or done this previously?

Thanks to all in advance!


Messages In This Thread
PEB Power Supply redesign - by bholcomb007 - 05-04-2015, 05:51 PM
RE: PEB Power Supply redesign - by sjt99 - 05-12-2015, 11:20 AM
RE: PEB Power Supply redesign - by bholcomb007 - 05-28-2015, 04:36 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)